Hi gang,

I recently had to replace my header pipes and 2-1 manifold.  I'll spare
the horror stories of getting the old rusty parts off.  Except to
mention the one broken stud that took more than 4 hours to coax out
using heat, PB Blaster, vice grips and patience.  And a sawzall is sure
handy.

Anyway, the new pipes and gaskets are great, but I can't seem to get the
dual-pipes-to-manifold joint to seal, where I have a noticeable leak.  

I think I need to loosen everything and start tightening at this
particular joint, but any suggestions are appreciated.

Gregory Smith
'88 Vanagon GL

Smith Design Studio
Small Building Company
Olympia, WA
360-239-0429
gregoryfsmith.com