but seriously, the sleeve is not *that" critical in ID, length is though.

alistair

On 2012-08-29, at 5:25 PM, neil n wrote:

> Hi all.
> 
> I'll be replacing the radius arm bushings. My bet is that the steel
> sleeves are at least pretty rusty. Those sleeves are NLA from VW.
> 
> I sourced some  DOM ROUND TUBE 0.750 X 0.120  (inch)  steel pipe locally from:
> 
> http://www.metalsupermarkets.com/catalog/STEEL-COLD_ROLLED/TUBE_ROUND/DOM
> 
> This pipe fits in the new rubber bushing, but the ID is *slightly*
> larger by 0.26 mm
> 
> Likely I'm being totally "Type A" about this, but is that 0.26mm
> anything to be concerned about? Like will that play cause wear,
> performance, alignment issues?
> 
> Thanks much,
> 
> Neil.
> 
> --
> Neil n
> 
> 65 kb image Myford Ready For Assembly  http://tinyurl.com/64sx4rp
> 
> '88 Slate Blue Westy to be named.
> 
> '81 VanaJetta 2.0 "Jaco"  http://tubaneil.googlepages.com/
> 
> Vanagon VAG Gas I4/VR Swap Google Group:
> 
> http://groups.google.com/group/vanagons-with-vw-inline-4-cylinder-gas-engines