Skip to main content
Gerry | Vanagon
Checking account...
← vanagon.com home · Continue the discussion in the forum
Subject:Re: Still need HELP with hot start problem 84 Vanagon!
From:OlRivrRat
Date:Mon, 3 Sep 2012 20:01:01 -0600

I recall my 83.5 having similar symptoms to that way back when it
was a few years old. It turned out

to be a weak cell in the battery ~ it had enough juice to crank it
quite nicely but when everything was warm or

hot the draw by the starter motor would not leave enough juice to make
the ECU happy. Try running with a 2nd

battery just sitting on the floor & jumpered in but disconnect from
the main batt' just incase it has a cell that is

pulling the power down.

                                                        ORR ~ DeanB

On 3 Sep , 2012, at 6:52 PM, George Averill wrote:

> All,
> Well, I need some more help.  I thought I had the problem solved,
> but it seems I don't.  If I keep replacing items, I may soon have a
> new bus!
>
> The problem is that the van will not start for about 45 minutes
> after it reaches running temperature and I turn it off.  It runs
> great while it is running.  Cold start is not a problem.  No
> problems at all.  If I drive about 20 miles and go in a store, when
> I return it won't crank.  If I wait for another 45 minutes or so it
> cranks.  Drive a few miles, turn it off to go in another store, and
> the same thing happens again.  The engine turns over, but no
> cylinders fire.
>
> I have done the following
> 1.  Replaced the ignition switch
> 2.  Replaced the coil
> 3.  Replaced the fuel pressure regulator
> 4.  Replaced the idle module
> 5.  Replaced the air valve
> 6.  Replaced the injectors
> 7.  Cleaned all ground connectors, those on the motor and the
> bonding cable between the frame and the transmission.  The van has
> never been to the beach or run on salted roads.  No corrosion any
> place.
> 8.  Replaced the temperature sensor.
> 9.  Replaced the wire from the computer to the temperature sensor.
>
> Tomorrow I am going to see if I can find some liquid air and try
> cooling down some connectors to see if that may be a problem.  I
> think that the last time this happened it was getting fire.  I will
> check again to be certain.
>
> Any suggestions will be appreciated.  I'm getting too old to keep
> this up much longer.
>
> George
> 84, Georgia