Dave,

This bit me once, I don't know if it will be your problem. There are two
heavy gauge wires running to the positive radiator fan terminal  post
connected through one ring terminal. I'm not in front of a Bently right
now, but one wire supplies the medium speed voltage from the resistor. In
my case, that one wire had high resistance at the ring terminal crimp, and
that fan would not operate. Conversely, the high speed would work; same
terminal. I replaced the ring terminal and all was well again (this on an
'87 Syncro).

Might not hurt to see if you are getting voltage through both wires by
carefully piercing the insulation with a tool of your choice near the ring
terminal.

Cheers,

Dave Milo

On Wed, Sep 19, 2012 at 4:29 PM, David Bjorkman <ddbjorkman@verizon.net>wrote:

> Hi Volks;
> Tried the jumper trick on the radiator thermo switch connector.  Only got
> fan running on high on outside connectors.  No responce when using middle
> connector.
> So, I think I am looking at the resistor as the culprit.  It seems the
> original type is not available and the available Eurovan type needs a plug
> transplant.  Probably not available at a FLAPS (let me know if I am
> wrong).  Oh well, not just a simple spin out the old switch and spin in the
> new one as I was hoping.  Anyone done this and can tell me if there is
> anything about the wire connections I should look out for?
>
> Dave B.
>