Just curious on the ground location out of the factory. I have rewired
the ground to the chassis near the pump on many vans.

Here's and update on the fuel pump problem. The fuel pump has no prime
cycle but is working during starting/cranking cycle and can run the
engine now if manually primed. Given that the f/p relay & pump are good
what could the issue(s) be causing no initial 3-8 second prime mode when
the ign. switch is put in ON position, ECU?

zzyzx wrote:
> Subject is a 1981 2.0L air cooled.
>
> The fuel pump & fuel pump relay have been bench tested and are good.
> However when they are installed in van the fuel pump does not receive
> current to actuate.
>
> The fuel pump ground wire tests good & continuity of positive wire from
> f/p to f/p relay tests good.
>
> Any suggestions?
>
> Also, I'm curious where the f/p ground wire attaches to the body.
>