At 02:56 PM 10/20/2012, turbowesty wrote:
>I bought an EGT gauge and sender. In order to install the sender I
>will have to take off the exhaust manifold, drill, tap and weld a
>bung on and then install the sender. Reassemble and I'm good to go.
>If I had a place to put it up on blocks, take the parts out and do
>the work over a day or 2 and then put it all back together I'd be
>thrilled. And I'd learn a bunch along the way. It's not a
>complicated thing, it's just complicated by circumstance. So

Peter, I'd think that your local muffler shop would be able to
install a bung in place in about fifteen minutes if the pipe is
sound.  Should be able to weld the bung on and then drill through the
middle.  Might need a right-angle drill to be able to get the bung up
onto the side of the pipe without moving it.

Yours,
David