Not sure aluma seal is so good for the radiator. You might have an over heating problem in the summer. If you plan on replacing the radiator when you do the engine change I would give it a try.
gary
�
�
Date: Sat, 29 Dec 2012 20:00:24 -0500
From: "kenneth wilford (Van-Again)" <kenwilfy@COMCAST.NET>
Subject: Re: drips of antifreeze off head

Marc, I would just add some aluma seal to the coolant and it will make the
slight drips go away for a year or so. These rubber head gaskets like to
seep when it is cold. As long as it is just a hanging drop or a drip or
two on the ground on a cold morning I wouldn't worry about it and the
sealant will seal it back up tight again.

Ken Wilford
John 3:16
www.vanagain.com

On Sat, Dec 29, 2012 at 5:52 PM, marc rose <mrose1028@gmail.com> wrote:

> 90 carat 2.1 aka "ROSIE". I have just finished installing some new bumpers
> I fabricated, changed the oil and changed the gasket on the oil cooler
> aswell as the hoses that go to it. I was looking under her three days ago
> and saw a drip of anti freeze hanging of the front side of the left head
> where the sheild bolts on and figured it was some left over from doing the
> hoses. I wiped it off and drove her around some and she ran as normal. I
> looked again today and there was that drip again.....nothing puddled on the
> shop floor though. The tanks look to have the correct level I was just
> looking for advice as far as how much should I drive it if it is a head
> gasket? I do plan on doing some sort of ugrade on her motor in the future
> just don't want to do it right now...
>
> thanks
>

------------------------------

Date: Sat, 29 Dec 2012 18:24:21 -0700
From: miguel pacheco <mundopacheco@GMAIL.COM>
Subject: Re: drips of antifreeze off head

Ditto what Ken recommended. Aluma Seal or Bars. I've used both. Follow the
instructions and proceed down the road with confidence. Great results!
Miguel