So what's the purpose of using the relay for this power socket? To turn it
off when you turn the backup light on? If using a switch and the relay is
also up front then why the relay?

Dennis

-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of
neil n
Sent: Saturday, February 16, 2013 3:03 PM
To: vanagon@GERRY.VANAGON.COM
Subject: 12 Volt + Wire Up Rear Pillar? (vent)

Hi all.

I've nearly finished installing a back up light. It's switchable from dash
(switch near shift lever when in reverse). Relay is a 5 pin waterproof type.

87a of relay is normally closed. As is, the wire from 87a is taped and
firmly cable strapped to the relay body well away from any metal.
But.....

Since this wire is #12, and NC engine off, it would be prime for a 12 Volt
outlet tucked up on RH side of rear upper Westy shelf

image. Arrow points to intended location:
https://lh6.googleusercontent.com/-qPdIzZgxrFY/UR_k7-An-KI/AAAAAAAAG7Q/zuzkW
dSefEA/s576/12%2520Volt%2520Outlet.jpg

I see this as a useful spot for running a compressor, rear light, etc.

Plan is to run the + supply wire up the passenger side vent, then through
interior wall.

Will securing wire at area behind tail light, and up higher near the vent be
sufficient?

FWIW, 30 + power is fused on the supply side of the relay.

Neil.

--
Neil n

65 kb image Myford Ready For Assembly  http://tinyurl.com/64sx4rp

'88 Slate Blue Westy to be named.

'81 VanaJetta 2.0 "Jaco"  http://tubaneil.googlepages.com/

Vanagon VAG Gas I4/VR Swap Google Group:

http://groups.google.com/group/vanagons-with-vw-inline-4-cylinder-gas-engine
s