old and brittle plastic bits ... of course I broke one. the locator pin, [face-plate anchor stem], (naughty word) can be reattached with a small blob of 2 part epoxy. you'll eventually have reason to pull the panel again so a little dab of anti-sieze on those clips might extend the life of those plastic parts and possibly make the next removal less stressful. � �h t h � � � � � � mike

________________________________
 From: David Beierl <dbeierl@ATTGLOBAL.NET>
To: vanagon@GERRY.VANAGON.COM 
Sent: Monday, March 4, 2013 3:19 PM
Subject: Re: Air and heat knobs on levers�
 
At 02:57 PM 3/4/2013, WILLIAM WITZ wrote:
> I was wondering if you can pull the
>plastic knobs on
>the air/ heat levers in order to remove the plate.�

The faceplate is held on by two plastic tits that insert into
spring-steel clips in the panel, bottom left and top right IIRC.� Pry
gently, very close to the pin -- you want absolute minimum bending
force on the pin.� If rust has formed on the clips they may be
frozen.� If one breaks off, I have successfully repaired them by
careful drilling a clearance hole in the broken part and a smaller
hole in the base and inserting a plastic (meant for, not made of)
screw from some long-vanished piece of gear.�

Yours,
David