Hi all.

I'm in the middle of a DC powered Truckfridge install. Plan:

run new Loomex from rear 110VAC outlet to a new outlet (or power bar)
at cabinet wall behind driver seat.

The original 110VAC wire to Dometic plug on my Canadian model Westy
runs over top of the shore power cord tube. Is this routing correct?
Or should it run under this tube? It wasn't strapped where it ran
behind the cabinet so I assume that any portion of this wire passing
behind the cabinet isn't required to be strapped.

Wire routing plan: run new wire behind the cabinet, then out and up
the RH rear corner inside the cupboard. It wold be protected with PVC
conduit.

Any pointers (strapping requirements etc.) are most welcome.

Neil.

--
Neil n

65 kb image Myford Ready For Assembly  http://tinyurl.com/64sx4rp

'88 Slate Blue Westy to be named.

'81 VanaJetta 2.0 "Jaco"  http://tubaneil.googlepages.com/

Vanagon VAG Gas I4/VR Swap Google Group:

http://groups.google.com/group/vanagons-with-vw-inline-4-cylinder-gas-engines