My head lights - which were working fine - are still out - and every
time I go to work on them  I get interrupted for extended periods - lose
my place - forget where I was, and have to start over.

Need help!

To repeat the story - made a stop at night - lights and ignition  off -
when I started it up - no lights. Did the ignition switch X circuit
check - and the lights flashed. Replaced the switch with a new one -
checked again - no lights at all. I have been unable to fix that. I NEED
to get those lights on, but this is turning into a real challenge.

Question: is there a way to temporarily install a bypass circuit to
power the lights - at least on the low beams so I can drive it at night,
until such times as I can find and fix the real problem?

Any help at all on this is appreciated.

Thanks.

John in Alabama