Frank Condelli(might be misspelled) from Canada mounted his there and
shared photo's of it.  He is active on the list at times and has a business
and website for Vanagons. If I get around to installing a propex that is
where I plan on mounting it also.  I do not want extra holes in our floor
pan and value the space under the seat too much.  Part of Franks
installation uses an area that is normally wasted as it is behind a false
wall between the cubby and the water tank compartment wall.  The false wall
is there to protect the shore power wiring and you will lose that
capability to mount your propex there but for me it is not an issue.  We
have never used shore power and probably never will most of the places we
camp it is not available even if we wanted it.  Mounting there allows the
air inlet and exhaust to go through the drivers side body panel eliminating
more holes( water entry points) in the floor.

Looking forward to your YouTube video as someday I may get bored enough to
tackle that job and am always happy to learn from those whom have gone
before.

Mark in AK
`87 Westy Syncro

On Sat, Mar 16, 2013 at 10:58 AM, Bryan Feddish <
uprightbassghost@hotmail.com> wrote:

> I�m painfully removing the camping gear at the moment and have my 90�s era
> Propex out along with the rear bench seat.  There is no way I am putting
> that Propex back in that same spot again. Way too much space wasted with
> that there.  I saw some picture where someone had placed in that small
> cubby on the bottom near the bottom of the water tank. Can someone send me
> some pictures of that install?  I think I can put it under the TruckFridge
> too but I�d lose my drawer there.
>
> And yes, I�m filming the removal of the camping gear since there are non
> available on YouTube.  It won�t be as funny as most as I have a bad back
> and crouching inside a van and yanking stuff is torture so I�m in a bad
> mood most of the time....
>
> Thanks,
> Bryan
>