I've had good results with that type of impact driver, usually on
philips head screws but it does work.

Rob
vwrobb@gmail.com

At  5/2/2013 12:45 PM, neil n wrote:
>Could a tool like this:
>
>http://www.amazon.com/Lisle-29200-Hand-Impact-Tool/dp/B0002NYDRG
>
>be used on the offending flywheel bolt? I have found this tool to be
>quite handy. (i.e. front brake splash guard screws)
>
>I know one doesn't have to pound the crap out of this tool to use it,
>but I have no idea if (effectively) banging on the end of the crank is
>a bad idea.
>
>Neil.
>
>
>On Thu, May 2, 2013 at 7:04 AM, Steve Cotsford <cotsford@aol.com> wrote:
>
> > Socket head cap screws are especially strong.
>
>
> > If you are fighting one off, try using a vice grips on the
> outside (very tight) and then giving the arm a good smack.
>
>
>
>--
>Neil n
>
>Blog: tubaneil.blogspot.ca
>
>'88 Westy http://tinyurl.com/c8rlw6p
>
>'81 VanaJetta 2.0 "Jaco"  http://tubaneil.googlepages.com/
>
>Vanagon VAG Gas inline-VR Engine Swap Group:
>
>http://tinyurl.com/d7gd5ej