If you must buy one here's a couple of places you can check out:

http://www.geneberg.com/cat.php?cPath=392_2919

http://www.piersideparts.net/SE98016.html

There was one for sale a few months ago on the Samba for less than half the prices quoted above but looks like it sold.

BenT
sent from my electronic leash

On May 11, 2013, at 7:24 AM, den jolliffe <sondancer77@YAHOO.COM> wrote:

> I need to open up the width of the sleeve landing surface/pocket in the head for wider cylinders/sleeves...this is a bolt on tool to the head or case (as I recall) that is driven by a drill press, and yes the cutting speed needs to be very slow and accurate, just knowing the name brought back a lot of memories.
>  
> Does anyone have one of these they are not using, or would be willing to loan out, or sell...or have a supplier they trust to buy one from?
>