Gene Berg did more for the aircooled engines than anyone would have thought
possible in an attempt to get Porsche power out of them:
http://www.geneberg.com/meetourteam.php  I've bought many of his parts over
the years, and since it isn't Friday here is the Vanagon content:  I added
his quick shift kit (http://www.geneberg.com/cat.php?cPath=17_486_2978) and
shift lever extender to my '84 Westy.  Very nice inexpensive options I
highly recommend.

Stuart
Automatic '85 Westy, 3 million shifts is enough.

-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of
Ben
Sent: Saturday, May 11, 2013 10:48 AM
To: vanagon@GERRY.VANAGON.COM
Subject: Re: Cutting tool question...cylinder head pocket

If you must buy one here's a couple of places you can check out:

http://www.geneberg.com/cat.php?cPath=392_2919

http://www.piersideparts.net/SE98016.html

There was one for sale a few months ago on the Samba for less than half the
prices quoted above but looks like it sold.

BenT
sent from my electronic leash

On May 11, 2013, at 7:24 AM, den jolliffe <sondancer77@YAHOO.COM> wrote:

> I need to open up the width of the sleeve landing surface/pocket in the
head for wider cylinders/sleeves...this is a bolt on tool to the head or
case (as I recall) that is driven by a drill press, and yes the cutting
speed needs to be very slow and accurate, just knowing the name brought back
a lot of memories.
>
> Does anyone have one of these they are not using, or would be willing to
loan out, or sell...or have a supplier they trust to buy one from?
>