Hopefully I'm not revealing a complete lack of geometry and basic math her
but....   ;)

When assembled in belt form, is a given belt measured at the inner or outer
face when determining "length" ?

I recently went through something similar and it seemed to me that for the
same application, one maker might advertise an OD length and the other
maker, an ID length.

Not saying this is the case with your belt situation, just tossing it out
there.    :)

Neil.

On Thu, Aug 15, 2013 at 7:02 AM, Mark McCulley <markmcculley@gmail.com>wrote:

> .....  I would think that 10 x 1075 means 10mm wide by 1075mm
> long.
>

>
> I checked with my local parts store yesterday to see what they had. They
> looked up my van on the computer, came up with a cross reference and pulled
> the part for me. I looked at it and the packaging said 10 x 1093. Not
> right. Asked for something closer to 1075 and they hunted around and came
> back with a belt packaged as 10 x 1080. Close. Then I looked at the belt
> and it was stamped 10 x 1093. Wtf.

--
Neil n

Blog: tubaneil.blogspot.ca

'88 Westy http://tinyurl.com/c8rlw6p

'81 VanaJetta 2.0 "Jaco"  http://tubaneil.googlepages.com/

Vanagon VAG *Gas* inline-VR Engine Swap Group:

http://tinyurl.com/d7gd5ej