The clip slides into place, sideways to the sensor. There should be a
little loop sticking out, about 1/2" across. Pull that loop out sideways.

Mark

David M wrote:
> Still not having any luck replacing this d*mn thing. I'm now on my third attempt after giving up twice. I've tried just about every tool in my toolbox to remove the clip. All my screwdrivers are too big, I tried using a slim nail and a small allen wrench. I cannot see the clip, so I don't know how much room I have to insert the tool. I'm also worried that I will either break or bend the clip or it will fly off never to be seen again. Already the sensor seems very loose but the clip is still on there. Is this a standard clip I could find in a hardware store? This would be so easy if the van was up on a lift but its really difficult from above.
>
> David ('87 Wolfsburg)
>
>
>
>