nice find.
nowyou need a good long, about 3 feet, solid cheater bar to use with
your two new tools.

even standing on the end of a very stout 3 1/2 long cheater bar
sometimes in not enough to unscrew that mutha.
I've had to heat a few of those nuts ( like one out of dozen or so ) ..
in one extreme case ..even with heating ...the nut galled the threads on
the stub axle taking the nut off.  Both nut and stub axle were ruined.
That only happened once in dozens of years though.

it's good to take things like the rear axle nut and flange apart once in
a great while ..make sure their not seized badly with rust etc.

scott

On 9/29/2013 4:01 AM, Stephen Grisanti wrote:
> I'm not looking forward to ever needing the 46mm socket for the big rear axle nut, but have always kept that measurement (and its standard 1 13/16" equivalent) in mind in case I trip over one, which I recently did.  Of course, after buying I find that NAPA stocks the non-metric one for $25 (on sale this week for $16!) but that Ohio antique mall was fairly boring until I hit a huge booth full of tools and the $5 find that is now living under the back seat of the '87 Westy with its new Harbor Freight 3/4" drive breaker bar.
>