My apologies Steve. The info I supplied from simply looking at the
Bentley diagram was misleading.

Thanks for the correction David! I assumed the white wire from ECU 12
to fuel injectors only supplied a switced ground. I think I understand
what you're saying; this wire switches from + to -  (engine running)
to open/close the fuel injectors.

Neil.

On 12/7/13, David Beierl <dbeierl@attglobal.net> wrote:

> With the system ready but idle you should have B+ on *both* sides of
> the injector plug.  If you don't then there's bad contact at the plug
> (or an open injector coil, of course).  When it runs one side pulses
> down toward ground for the duration of the injector opening.  If your
> Fluke can measure duty cycle you can see that happening.
>
> All the injectors are switched by the same transistor, so if you're
> getting pulses on some lines and not others it's a wiring issue.
>
> Yrs,
> d
>

--
Neil n

Blog: tubaneil.blogspot.ca

'88 Westy http://tinyurl.com/c8rlw6p

'81 VanaJetta 2.0 "Jaco"  http://tubaneil.googlepages.com/

Vanagon VAG *Gas* inline-VR Engine Swap Group:

http://tinyurl.com/d7gd5ej