Thanks. This effort was just to separate the connector from the sensor -
not remove the sensor itself.

John

On 12/29/2013 8:26 PM, OlRivrRat wrote:
>          JR
>
>      Assuming this pertains to your 88GL2.1L ~ You Push or SqueezeDown
> (if you have it ConvenientlyOriented) on the WireClip & then if it
> TheConnector does not want to come off easily you will probably need to
> push a ScrewDriverBlade between TheConnector & TheSensor & then give the
> ScrewDriver a GentleTwist ~ To remove the Sensor you Pull the
> RetainingClip completely out & then Pull the Sensor out ~ Coolant
> Will/Should Flow ~
>
>                                                      ORR ~ DeanB
>
>
> On 29 Dec , 2013, at 11:38 AM, JRodgers wrote:
>
>> I need to release the Temp II sensor.
>>
>> Question: Does one push the release clip - or pull the release clip - to
>> unlock and free the connector.
>>
>> Having a problem getting it loose and it's hard to see the action from
>> on top.
>>
>> Getting underneath to look isn't an option for the time being. It's been
>> raining and water is running under the van.
>>
>> Thanks,
>>
>> John
>
>