Is there any place to send that controller and have it tested??  Someone
was working on d Digitized version but it's been a while sincee there
was a post on it.

John

On 2/21/2014 3:11 PM, Dennis Haynes wrote:
> Most likely you have a bad idle valve controller. There are a number of outside factors that can cause this. Temp 2 sensor goes to the ICU and if a 2.1 system was added to a 1.9 ECU may be part of the problem. A bad ground for the temp 2 sensor can also be a problem along with the sensor itself.
>
> Dennis
>
>
> -----Original Message-----
> From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of Chris S.
> Sent: Friday, February 21, 2014 3:33 PM
> To: vanagon@GERRY.VANAGON.COM
> Subject: Idle question
>
> My '84 with DJ code WBX has an interesting issue. The idle control system is same as a 2.1l MV. It idles high, but when I unplug the ICV it purrs like a kitten at proper rpm. Plug ICV back in and it shoots up again. I've set and reset idle a few times now after I cleaned ICV internals.
>
> Any ideas?
>
> Chris.
>
> Wysłane z iPhone'a
> .
>