

| Subject: | Re: Question about mounting the Westy single mudflap |
| From: | Alistair Bell |
| Date: | Sun, 23 Feb 2014 09:02:47 -0800 |
I think the insert/grommet to be used is this one http://m.vwheritage.com/productDetails.cfm?iItemID=56003 Part number 865853231A Well, it is the correct part for the stock westy driver's side mudflap Alistair > On Feb 23, 2014, at 8:53 AM, Jim Felder <jim.felder@gmail.com> wrote: > > I wasn't going to gripe too much about the availability, but since the subject has been brought back up, here goes: > > I bought the flap from van-cafe. Their site showed a little bit of hardware pictured with the mud flap, and didn't say anything about "you may need to buy hardware kit so-and-so to install this part on your car," I figured I was getting what I needed with my pricey part. > > Yesterday I went to install it and discovered that there were, indeed, missing parts that I would need. So, I went back to the website. The parts kit came up in a search. Five buck, not bad, I thought. I ordered two. > > Then came the calculate shipping part. I entered my zipcode and was rewarded with a $17.00 shipping estimate for my one-ounce order. > > Needless to say, order canceled. > > I checked the Bus Depot site and they do not even list the parts, though they sell the same item, so I could not compare the shipping. > > So, I will be at the dealer parts counter sometime monday. Or Fastenall? > > Jim > > >> On Sun, Feb 23, 2014 at 10:10 AM, Alistair Bell <albell@shaw.ca> wrote: >> I might have the part number around here somewhere... >> >> >> >> >> >> > On Feb 23, 2014, at 5:25 AM, Jim Felder <jim.felder@gmail.com> wrote: >> > >> > Thanks Alistair. Looks like I will be visiting the dealer after lo these many years. >> > >> > Jim >> > >> >> On Feb 22, 2014, at 8:27 PM, Alistair Bell <albell@SHAW.CA> wrote: >> >> >> >> You need to buy the special plastic and steel inserts that go into the hole. One time use only so by extras incase you screw up. >> >> >> >> No need to get at the hidden side of the body, just push the buggers in and then screw the mudflat stud in. Then fit the mudflow on the stud. >> >> >> >> VW dealership has them, used on other cars. >> >> >> >> Alistair >> >> >> >> >> >>> On Feb 22, 2014, at 6:23 PM, Dave Mcneely <mcneely4@COX.NET> wrote: >> >>> >> >>> Jim, I assure you you do not have to do that. Unfortunately, I cannot recall the details of the installation, but I managed it, so so can you. When I figured it out, it made sense, but for the life of me I can't remember. Sorry. mcneely >> >>> >> >>> ---- Jim Felder <jim.felder@GMAIL.COM> wrote: >> >>>> I am celebrating ten years of westy ownership by installing the left front >> >>>> mud flap that protects the propane equipment. I got a really nice one, but >> >>>> one thing has me puzzled. >> >>>> >> >>>> It's obvious that the two studs that hold the upper part of the flap to the >> >>>> side of the Westy go in from the outside and need nuts installed on the >> >>>> inside to fasten them. But where and how do you access those two holes from >> >>>> the inside to install those nuts? >> >>>> >> >>>> I am hoping I don't have to pull the kitchen cabinet just to get to them. >> >>>> >> >>>> Jim >> >>> >> >>> -- >> >>> David McNeely >
Have something to add on this topic today? Revive this thread in the forum »