I would be VerySurprised if a Temp2Snsr Issue would cause a NoStart ~ especially a NoSparkNoStart ~

                                                        ORR ~ DeanB

On 11 Mar , 2014, at 7:55 AM, JRodgers wrote:

> Yes, Scott. I am familiar. Went through this back through Christmas with
> this same machine. Finally figured out it was the hall sender. It was
> actually broken. Replaced it with one from an engine that is out of
> service. Now this - symptoms that are the same as the old broken sender.
> I considered that the hall sender might be failing - but I wasn't where
> I could do the hall sender test. Didn't have ANY tools with me when this
> happened. Will be prepared next time it faults however. Then I can test.
> But in the mean time - what else? Ken suspects the Temp II sensor is
> getting funky!
> 
> John
> 
> On 3/11/2014 1:23 AM, SDF ( Scott Daniel Foss ) wrote:
>> this is exactly what a dodgy Hall Sender looks like.
>> 
>> On 3/10/2014 9:31 PM, JRodgers wrote:
>>> Argh!
>>> 
>>> Wouldn't you know - after selling off Volksiebus, Ol'Red decides to go
>>> on the fritz - again!! Left me stranded in the Grocery Store parking lot.
>>> 
>>> After coming out of the store, attempted to start and it was no go.
>>> Grind, Grind, Grind went the starter. I got out, did a distributor wire
>>> check - no spark. Waited a few, tried again. lots of spark. Put it
>>> together, tried to start - grind, grind, grind - no start. not even a
>>> spit.
>>> 
>>> Engine was hot, and the fuel pump would run, so I decided two wait a
>>> bit, then try again. I walked to some local stores and an hour later
>>> came back. Vroom, Vrooom! it fired right up,
>>> 
>>> This is a puzzle. Any suggestions as to where I might start looking for
>>> a fault?? Seems heat related.
>>> 
>>> Thanks..
>>> 
>>> John
>>> 
>>