sorry for all the emails.

re: "Automotive Goop". Since I threaded the bleeder screw into the
snapped off nipple hole, and since I applied Goop to exterior, it
might be ok for limited exposure to gasoline but who knows?

Neil.

http://eclecticproducts.com/_tds/automotive.pdf

SOLVENTS THAT DISSOLVE AMAZING GOOP®

"...... Gasoline  ......
These are common solvents that dissolve AMAZING GOOP® when hardened
samples were immersed. The dissolution with these solvents was not
instantaneous and therefore does not preclude usage in all cases.
Applications were an occasional splash or brief exposure is expected
may be acceptable. Test a small area before full use. "

On 3/10/14, Neil N <musomuso@gmail.com> wrote:
> Hi all.
>
> As I was advised, inspected both expansion tanks. Pass. side tank
> grommet had held ok with epoxy. But the driver side, well .....
> (image):
>
> http://tinyurl.com/okz6jt8   Obviously not an acceptable repair or
> really even a repair for that matter. This was done earlier in my
> Vanagon "career".
>
> More here showing crazing and crack.
>
> https://picasaweb.google.com/musomuso/VanagonGasEVAP
>
> You really have to look close and carefully push on the plastic to
> inspect. The area that shows crazing was quite soft.  (wear from water
> off tire?)
>
> Thankfully I have a spare tank though it's been repaired with a brake
> bleeder and Goop. It will be replaced post haste.
>
> Enjoy!
>
> Neil.
>
> --
> Neil n
>
> Blog: tubaneil.blogspot.ca
>
> '88 Westy http://tinyurl.com/c8rlw6p
>
> '81 VanaJetta 2.0 "Jaco"  http://tubaneil.googlepages.com/
>
> Vanagon VAG *Gas* inline-VR Engine Swap Group:
>
> http://tinyurl.com/d7gd5ej
>

-- 
Neil n

Blog: tubaneil.blogspot.ca

'88 Westy http://tinyurl.com/c8rlw6p

'81 VanaJetta 2.0 "Jaco"  http://tubaneil.googlepages.com/

Vanagon VAG *Gas* inline-VR Engine Swap Group:

http://tinyurl.com/d7gd5ej