If it's the point type, check the point gap.  They're bad about breaking
part of the rubbing block off after sitting a while.

GregM

-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of
Jonce Fancher
Sent: Sunday, April 20, 2014 2:27 PM
To: vanagon@GERRY.VANAGON.COM
Subject: Starts strong Now No Start HMMM

Hi all

Here is the Poo!

82 Westi with stock motor. 2.0L Air Cooled Been in storage for 3-5 years.
Had no spark.
Swaped points spark is good.

Everything is complete and ran when stored.

Started up with just set of points.
Lots of Noises Valves etc. Etc.

let run for 30- 40 min. Drove up the drive and back a few times, Brakes
would not allow a long drive.

Idle and strong power and very little smoke, ALL the noises went away.
Sounded like a winner.

let sit after stopping the motor to play with the sliding door that would
not let go.
Got the slider to work just fine.

Decided to start the Vanagon just for fun to hear it purr. (really it ran
absolutely Perfect)

Motor would turn and acted like No Compression at all no fire just spin with
the starter.

Acts like No compression and spins free. No Idea. Did the lifters overcharge
and the valves are just floating??

Very weird.

Did not look deep. Just spun like no pistons were connected to the crank.

Any one, Any one Bueller???

Jonce
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 10.0.1432 / Virus Database: 3722/6873 - Release Date: 04/21/14