Mark,

Thanks for the tips. I pulled the relay out of the socket, stuck in two
flattened wires - one in the 30 and one in the 87, connected the remote
switch alligators to the wires, moved the tranny to neutral, turned on
the switch, went back and pulled the trigger. Engine turned right over
and kept turning as long as the trigger was pressed. Tried to start -
but didn't - and there-in is my problem. But I will work on it tomorrow.

Thanks again.

John

On 6/21/2014 9:31 PM, mark drillock wrote:
> The better way to do this is to install a "hard start relay" and then
> use that to also act as the remote starter switch connection.
>
> Mark
>
> JRodgers wrote:
>> Larry, thanks.
>>
>> I think I'm going to bring a permanent wire out from the solenoid into
>> the engine bay and tie it off so I don't have to go through this again.
>>
>> John
>>
>