Skip to main content
Gerry | Vanagon
Checking account...
← vanagon.com home · Continue the discussion in the forum
Subject:Re: AFM test readings
From:Harold Teer
Date:Thu, 3 Jul 2014 09:03:28 -0400

Neil,

Thanks for alerting me to the video.  Here is the link to the thread and
video.  "
http://www.thesamba.com/vw/forum/viewtopic.php?t=369815&postdays=0&postorder=asc&highlight=tencentlife+afm+video&start=0
"

I had previously tested without power to the AFMs and noticed a linear
change in one and a jerky change in the other.  From the video, it appears
I need power for the proper test and will try that later today.

We had a pretty hefty thunder storm yesterday afternoon and early evening
and I lost my internet cable connection which is still out and it appears
that my cell phone is bricked.  Off to the store to see about a replacement.

Thanks,

Harold

On Wednesday, July 2, 2014, Neil N <musomuso@gmail.com> wrote:

> I don't have enough knowledge to speak to actual resistance values,
> but tencentlife on thesamba.com posted a neat video of an analogue
> volt-ohm meter being used to measure consistency of resistance value,
> as the flap is moved. I gather that his point was to observe if there
> were any drop outs when slowly moving the flap.
>
> The resistive track tends to wear more at commonly used positions.
> Idle, cruising speeds.
>
> Image showing what is likely minimal wear on my AFM resistive track:
>
> http://tinyurl.com/pon4jjw
>
> the arrow points to what is likely around town speeds. You can see
> similar wear to LH (highway cruise speeds. Note no wear at LH of
> track) and at RH. (idle)
>
> Neil.
>
> On 7/2/14, Harold Teer <teer.vanagon@gmail.com <javascript:;>> wrote:
>
>
> > My question concerns the measurement between terminals 2 & 3  --- Bentley
> > says the value should be a resistance change when the air sensor flap is
> > moved
> >
> > But, does it matter what the range of change looks like?  It it starts
> out
> > as .55 but changes to a high of 1.5 somewhere along the movement of the
> > flap, is that better than a high value of 1.2 or even a high value of .6
> > since any of those would provide a resistance change.
> >
> > Or, should I be looking at values when the flap is fully opened?  Or
> should
> > I be looking for some other variance?
>
>
> --
> Neil n
>
> Blog: tubaneil.blogspot.ca
>
> '88 Westy http://tinyurl.com/c8rlw6p
>
> '81 VanaJetta 2.0 "Jaco"  http://tubaneil.googlepages.com/
>
> Vanagon VAG *Gas* inline-VR Engine Swap Group:
>
> http://tinyurl.com/d7gd5ej
>

--
Harold Teer
1991 Westy -- VANGAUX
Harrisonburg, VA