Is your fill pipe one with the ball check on the end? The cage may be bent or collapsed.

Dennis,
From my phone.
________________________________
From: George Laubach<mailto:skiplaubach@COMCAST.NET>
Sent: ‎7/‎13/‎2014 8:28 PM
To: vanagon@GERRY.VANAGON.COM<mailto:vanagon@GERRY.VANAGON.COM>
Subject: At the pump fueling issue

Good summer to you,

Digijet, '84 Westy, 2.2 GoWesty kit in a 1.9 block.

Last night I lowered the fuel tank and sealed the fuel level sender using Permatex Permashield Fuel Resistant Gasket Dressing & Flange Sealant #85420.

Then, at the pump today I put the pump handle at slowest fill click and the gas overflows out of the fill hole (at the body panel) after about 1/2 gallon goes into the tank. I did manage to get about six gallons in...albeit slowly.

New tank (6 months) new sender (also 6 months - been leaking due to not so tight seal), newish seals on the tank, crossover line goes up and over the coolent lines, etc.

I reached in to check the crossover and the vent lines and all appear copacetic. I unscrewed the three fasteners holding the fill tube and fiddled with it a bit, it seems to be in a happy position.

What gives? It seems like an obstruction, or an air vent situation?  Anyone else experience this or can offer opinions, theories or answers/solutions?

Thanks,

Skip

Sent from my iPad