thanks Jim. The newer chain lube i purchased isn't the same as old
type which was thicker. Was looking for something else (on hand) I
could use. Too many spray cans in the shop!

Light or heavy mineral oil is same or similar to the sewing machine
oil? I'd think rigging up a small tube and drip some of that in would
be "easy".

IIRC, someone in the thread I linked to used PB blaster which AFAIK,
is not the right stuff.

On 11/23/14, Jim Felder <jim.felder@gmail.com> wrote:

> I have had them apart like shown in the samba link. Someone on our list had
> an even better  tutorial, it has worked great on several motors. After
> refurbishing sewing machine motors for years, I can tell you that I have
> had good success with sewing machine oil--nice and thin--and pack in and
> around the bearings with Singer grease. It comes in a tube, and when it
> gets hot from friction, it melts a little bit of itself again and again for
> years. If you could find some sintered or oil filled bronze bearings to
> fit, or sealed bearings, you would never have to do this again. But without
> that, the grease and oil seem to be a reasonable solution.
>
> Some people, even in the sewing machine community, use tri-flow, a bicycle
> chain lubricant with teflon powder, basically. Since a bicycle chain gets
> up to maybe 100 degrees, I am not certain that a lubricant designed for a
> chain would work well in the tight clearances and higher temperatures of an
> electric motor. So, I stick with sewing machine oil and singer grease. I
> have never had to re-do one, but I hope to live long enough to have to.
>
> If you are going to use the Mullendore Port of one if its variants, just
> use spray lithium grease.

--
Neil n

Blog: Vanagons, Westfalia, general <http://tubaneil.blogspot.ca>

1988 Westy Images <https://picasaweb.google.com/musomuso/New1988Westy>

1981 Westfalia "Jaco" Images, technical <http://tubaneil.googlepages.com/>

Vanagon-Bus VAG Gas Engine Swap Group <http://tinyurl.com/khalbay>