Yes, but in my opinion NAPA is one of the better chains.

Thanks, Tom Hargrave
www.kegkits.com
www.stir-plate.com
www.towercooler.com
www.grow-sun.com
www.raspberryproject.com
http://goo.gl/niRzVw

-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@GERRY.VANAGON.COM] On Behalf Of
Dennis Jowell
Sent: Tuesday, January 13, 2015 5:14 AM
To: vanagon@GERRY.VANAGON.COM
Subject: Re: Source for reliable axle assemblies

Quick question is FLAPS like a NAPA store out here in New England?

Dennis Jowell
Scotch Hollow Farm
Newbury, Vermont

> On Jan 12, 2015, at 8:23 PM, Jim Felder <jim.felder@GMAIL.COM> wrote:
>
> I don't know what your situation is exactly, but if this applies to
> it, you can go to a FLAPS and buy a needle injector that will snap
> onto your grease gun. This will penetrate the rubber boot and apply grease
to the CV joint.
> Not perfect, massaging the boot will help. If simple lubrication is
> your problem, this technique, if done right with say 15 strokes of the
> gun, could help. If you have some other problem, it's won't help.
> Sounds like you are getting to your early, though.
>
> Jim
>
>> On Mon, Jan 12, 2015 at 4:03 PM, John Seehorn <jseehorn@hotmail.com>
wrote:
>>
>> Thanks for all of the suggestions.  I did check for loose bolts and
>> found a couple loose on the RH side outer.  I'm positive they were
>> tight at installation and tightening them did not make the noise go
>> away.  So I suspect that the RH axle is the one causing the noise.
>> I'm going to try swapping the axles first.
>>

-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2015.0.5645 / Virus Database: 4257/8895 - Release Date: 01/09/15