This is the part number that I bought a while back that wound up being
the wrong length.  I would measure what you have and then have them
measure what they have, just to be sure you are both on the same page.

Ken

On 2/9/2015 4:11 PM, Jeff Schwaia wrote:
> Only $27 brand new from Van Café:
>
> http://www.van-cafe.com/home/van/page_1685_716/new-push-rod.html
>
> Cheers,
>
> Jeff
>
>
> -----Original Message-----
> From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of kenneth wilford (Van-Again)
> Sent: Monday, February 09, 2015 6:09 AM
> To: vanagon@GERRY.VANAGON.COM
> Subject: Re: 2.1 L push rods
>
> John, I have used ones in stock.  I usually sell them for $40 each plus shipping them to you via priority mail shipping which is an additional $7 for as many as you may need.  There some aftermarket ones listed out there but all of them I have purchased have been a different length than the stock waterboxer push rods.  Just found out that they are the correct length for some of the aircooled Vanagon 2.0l engine, even though I thought those were the same as the bus AC push rods (live and learn).
>
> Let me know if I can help you further.
> Ken
>
> On Sat, Feb 7, 2015 at 3:23 PM, John Rodgers <jrodgers113@gmail.com> wrote:
>
>> Finally got around to fixing my pushrod tube leak. Found there was a 4
>> inch crack in one tube. Upon disassembly and removal of the push rods,
>> I found two of them bent. Probably accounts for the one cracked tube
>> at least. On the passenger side, as seen from the rear of the van,
>> from back to front, it was the 2nd and 4th push rod.
>>
>> The engine has run fine, but for the oil leak. But this has to be fixed.
>> Anyone have  two or four pushrods from a junked 2.1 L that they care
>> to part with? Would be much appreciated. My van is down for the count
>> as it sits.
>>
>> Thanks,
>>
>> John
>>
>
>
> --
> Thanks,
> Ken Wilford
> John 3:16
> www.vanagain.com
>

--
Thanks,
Ken Wilford
John 3:16
www.vanagain.com
Phone: 856-327-4936
Fax: 856-327-2242