Kevin, I would also replace the oil cooler o-ring if you haven't done that
yet.  You won't lose much oil either way.  The sensor just a few
tablespoons.  The oil cooler o-ring, less than half a quart especially if
you don't dump out the oil filter.  Hope this helps.

Ken Wilford
John 3:16
www.vanagain.com

On Thu, Mar 5, 2015 at 10:50 AM, Kevin Duvernay <kduvey@gmail.com> wrote:

> I'm swapping out my motor mounts tomorrow. While I'm there I'm also going
> to replace the #2/4 header. If that goes smoothly, I've also got a new
> water pump along with all new coolant pipes/gaskets and hoses (its
> basically the last bits of my complete cooling system overhaul!)
>
> Anyways, I figured while I'm there doing all this I minus well toss in a
> new high pressure oil sender (the grey one, .9 bar). What I'm wondering is,
> is it possible to do this without loosing too much oil? I JUST changed the
> oil out to some really expensive Redline synthetic stuff, would hate to
> waste any of it...
>
> Also, anything else I should address while I'm back there?
>
> Kevin
>

--
Thanks,
Ken Wilford
John 3:16
www.vanagain.com