

| Subject: | Re: 2.1L WBX -oil pressure light flickers at idle |
| From: | Dave Mcneely |
| Date: | Sun, 1 Mar 2015 10:14:35 -0600 |
This is a real possibility. I had this situation, and cured it with a Ten Cent Life external oil cooler. As I related on here before, I realized what was going on when I drove up Raton Pass from 100+ F summer heat through a thunderstorm in which the ambient temperature dropped to 45 F and watched the oil pressure rise from about 15 psi cruising to over 40 psi when cruising at the top of the pass. mcneely ---- Raymond Markett <raym02@YAHOO.COM> wrote: > Is it possible that your engine oil is getting too hot? Perhaps the oil cooler malfunctioned after being disturbed. > Oil pressure tends to drop as the oil heats up. > > Sent from my iPhone > > > On Feb 28, 2015, at 11:44 AM, John Rodgers <jrodgers113@GMAIL.COM> wrote: > > > > Oil is Kendall GT-1 20W50. > > > > At idle, flickering light, turn the engine off, then restart, the light no > > longer flickers. It might, or it might not, flicker at the next stop. > > > > I have never had a low oil pressure indication before. But the engine was > > out of service while the oil cooler seal was replaced and two pushrod tubes > > were replaced on the side opposite the oil pressure switch. That switch was > > undisturbed. When the van was again put on the road, the first time out, > > the light flickered at a stop. Am mystified why it has never flickered > > before, now suddenly it does. Engine has 114, 000 odd miles on it. > > > > John > >> On Feb 28, 2015 12:58 PM, "Dan N" <dn92610@gmail.com> wrote: > >> > >> either the oil pressure sensor are bad or you have a low oil pressure .. > >> > >> what grade of oil are you using? > >> > >> On Sat, Feb 28, 2015 at 10:45 AM, John Rodgers <jrodgers113@gmail.com> > >> wrote: > >> > >>> The oil pressure light comes on after a long run at speed when I have to > >>> drop to idle and stop for traffic or a stop light. Doesn't happen every > >>> time but frequently enough to keep me spooked. I have checked the wires > >>> and > >>> found no faults. What is happening. What else might cause this? > >>> > >>> John > >> > >> -- David McNeely
Have something to add on this topic today? Revive this thread in the forum »