

| Subject: | Re: Where to get a decent paint job? (long) |
| From: | Jim Felder |
| Date: | Wed, 29 Apr 2015 16:53:48 -0500 |
I have done this exact thing, and you can't tell those windows from the ones where I replaced the rubber. I used paracord from harbor freight, and used a hooked puller to pull the seal up. Jim On Wed, Apr 29, 2015 at 4:19 PM, Stuart MacMillan <stuartmacm@gmail.com> wrote: > It's all about the prep. > > If you are not removing all the windows, try an old school trick before > you drop it off. Get some cotton cord about 1/8" diameter and use a plastic > knife to lift up the edge of the window rubber and stuff that cord under > it. It will lift the rubber (unless it's hard as a rock) off the body > preventing that hard paint edge that often starts to peel after a paint > job. It also makes sanding and masking easier, and allows the paint to > come up under the rubber a bit. > > Tape one end of the cord to the window for pulling it out later, and pull > it out by pulling towards the inside of the window. > > If you are painting the top too now is a good time to remove the seals for > painting and get new ones. You can take off the front part and they can > paint it on a rack. You'll eliminate another hard paint edge. Get new SS > screws to re-install. > > If you do some of the prep like this, you'll likely be happy with the > job. But if you have rust under the window rubber, you should remove the > window and clean it all out first. > > Stuart > > -----Original Message----- > From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf > Of PB > Sent: Wednesday, April 29, 2015 12:45 PM > To: vanagon@GERRY.VANAGON.COM > Subject: Where to get a decent paint job? (long) > > I've been asking around about the cost of a paint job. The first body shop > I asked told me it would cost $7,000 and suggested that I try Maaco, so I > went to 2 Maaco's - only about a mile apart! > > The first guy told me that all I needed was their basic paint job at a cost > of $1,300, including fixing a small dent at the front driver side signal > light area. About 6 years ago my husband took his badly dented 1996 Camaro > there and was very pleased with their work, service, and pricing. > > As I was arriving at the SECOND Maaco, a beautifully painted 2-tone car > with a graphic design on it was leaving out the driveway. In the shop there > was a beautifully painted red and white VW Camper pop-top BUS that they had > just restored. He suggested their best paint job at a cost of $2,000, > including color, sand, and buff. > > I don't mind paying an extra $700 if the quality would is greatly superior > to the econo job. Neither of the guys tried any hard sell tactics, and took > their time explaining and answering all of my questions. > > Does anyone have experience with Maaco or any other "econo" paint places? > I can't do any prep by myself, and not willing to pay several $,$$$'s. > > Description of Maaco basic paint jobs > <http://www.maaco-vannuys.com/auto_paint.html> > Maaco Platinum Paint Job > <http://www.maaco-vannuys-north.com/auto_paint.html> > > Patti > 90 Westy Automatic > Los Angeles > > > > -- > > *♪♫**♥**♫♪♪♫**♥**♫♪♪♫**♥**♫♪♪♫**♥**♫♪* > If it's not on my Smart Phone, it doesn't exist... > ●▬▬▬▬▬▬ஜ۩۞۩ஜ▬▬♥▬▬▬ஜ۩۞۩ஜ▬▬▬▬▬● >
Have something to add on this topic today? Revive this thread in the forum »