BTDT. They will take 3mm shims for each shoe.

Dennis,
From my phone.
________________________________
From: Neil N<mailto:musomuso@gmail.com>
Sent: ‎6/‎7/‎2015 9:53 PM
To: Dennis Haynes<mailto:d23haynes57@hotmail.com>
Cc: vanagon@gerry.vanagon.com<mailto:vanagon@gerry.vanagon.com>
Subject: Re: Brake Shoe Lower Mount Shims: Make-Install Shim Over Pins?

Larry, Dennis, thanks much.
I get to buy more tools!

I've emailed Bus Depot regarding their higher end brake shoes:
http://www.busdepot.com/251609537l
I'll be curious what the lining thickness is. (thought that's not the
only factor I know)

The Raybestos Deluxe shoes I have in there have held up well but
while recently burnishing in new front pads, (after re-adjusting shoes)
the RR shoes and drum got singed; I knew they were tight but
even after backing off the adjuster, they still heated up the drum
while driving, no brakes applied.

Neil.

On 6/7/15, Dennis Haynes <d23haynes57@hotmail.com> wrote:
> Get a right sized set of vice grips and try twisting them loose. Sometimes
> they come out without much fuss. An air-acetylene (plumber's torch) or MAPP
> may do the trick.
> Consider getting a set of shoes from GoWesty. I do not know where they get
> them from but so far they are almost a factory fit. With new drums the most
> you will get in place of a shim is 1mm on the front shoe. Most of the other
> shoes I have tried will take 3 to 5mm sometimes for both shoes. The next
> best set I have found come from AutoZone. Go figure.

--
Neil n

Blog: Vanagons, Westfalia, general <http://tubaneil.blogspot.ca>

1988 Westy Images <https://picasaweb.google.com/musomuso/New1988Westy>

1981 Westfalia "Jaco" Images, technical <http://tubaneil.googlepages.com/>

Vanagon-Bus VAG Gas Engine Swap Group <http://tinyurl.com/khalbay>