Thanks Dennis!  I probably did this job in a couple hours back then.  I'm
allowing a half day now.

Stuart

-----Original Message-----
From: Dennis Haynes [mailto:d23haynes57@hotmail.com]
Sent: Monday, July 06, 2015 8:22 PM
To: 'Stuart MacMillan'; vanagon@GERRY.VANAGON.COM
Subject: RE: Size of shortened hex key for replacing H20 pump on a 1.9?

6mm

Dennis

-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of
Stuart MacMillan
Sent: Monday, July 6, 2015 10:32 PM
To: vanagon@GERRY.VANAGON.COM
Subject: Size of shortened hex key for replacing H20 pump on a 1.9?

I made one of these about 20 years ago and now can't find it.  It's for the
cap screws that are too close to the exhaust pipe for even the short arm,
and I'd like to make one before I start the job.

I know somebody out there has one!

Thanks!

Stuart