I like the GW circuit replacement, but it's cheaper to add an oil pressure
gauge and voltmeter if this is all that's not working, and you should have
these anyway.  Be sure to check the plug, and clean the foil connectors
gently with a pencil eraser.

Stuart

-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of
Jack Reynaert
Sent: Thursday, August 20, 2015 3:40 PM
To: vanagon@GERRY.VANAGON.COM
Subject: Re: Red LED bulb

Jeff,

Chances are that the bulb is fine... and that your printed circuit board is
failing.
Put an ohm meter on the bulbs first to test them, before ordering.

Basically, any 12v LED bulb work.

My Hi-Beam bulb is out, tested it and the problem is on my circuit board.
At this time, that is the only problem with my board.

Our friends board just failed in a few area, so we bit the bullet and
purchased the GoWesty kit to rebuild the dash.
About 2 to 3 hours to do it, but no more problems or future failures.

Good luck!

Jack

-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of
Jeff Palmer
Sent: Thursday, August 20, 2015 6:26 PM
To: vanagon@GERRY.VANAGON.COM
Subject: Red LED bulb

Anyone know where I can get a replacement bulb for my alternator and oil
pressure lights? GoWesty refers to them but I can't find them on the site.
85 if it makes a difference.

Thanks
Jeff

Sent from my iPhone=