Doesn't work. To short. Can get the alternator brace on, and the dip stick
piece if I hold it there, but there is not even room for a washer, even a
thin one, much less a nut.

John
On Oct 10, 2015 21:57, "SDF ( aka ;jim lahey' - Scott )" <
scottdaniel@turbovans.com> wrote:

> 11/16ths is almost 3/4 of an inch ..'about right'.
>
> Even if you have 1/2 inch of stud sticking out that should be sufficient .
>
>
> On 10/10/2015 9:08 AM, John Rodgers wrote:
>
> Pat, is yours long enough to get the alterator bracket, the dip stick
> bracket and the retaining washer and nut on it.? 11/16ths seems mighty
> short. I talked with Chris at VAN CAFE and he said that should be an 8mm X
> 38  stud stiking out. I suspect it should have at least 1 inch exposed to
> mount those brackets.
>
> John
> On Oct 10, 2015 13:40, "Pat Spragge/RFAN" <Pat.Spragge@rfan.com> <Pat.Spragge@rfan.com> wrote:
>
>
>
> John,
>
> I can't tell you how long the stud is, however it protrudes 11/16" on mine.
>
> Sent from my iPad
>
>
> On Oct 9, 2015, at 3:40 PM, John Rodgers <jrodgers113@GMAIL.COM> <jrodgers113@GMAIL.COM> wrote:
>
> Next question! I just discovered a broken stud. This stud is on top of
>
> the
>
> engine, lies just to the right of engine center line and faces the rear
>
> of
>
> the van. It's apparent use is as an anchor for part of the alternator
> tension adjustment apparatus. Two brackets fit over it and a nut secures
> them. How long should that stud be? I cannot mount both brackets to it
>
> and
>
> get a washer and nut on it to lock it down.
>
> Any input on this new problem is appreciated!
>
> John
>
>
>
>