Would a piece of steel square bar fit the 3/8" drive socket?
Put an open end wrench on that?
I've seen square tube at hardware stores.
Would a suitable length of that be strong enough?

On 11/16/15, Frank Condelli <RAlanen@aol.com> wrote:

>         As Denis says, however I have never needed to remove the pulley.  I
> use 1/2” drive socket then use a 3/8 reducer inserted 1/2 way into the 24mm
> socket then use a 1/2” ~ 13mm open end wrench on the reducer to turn the
> socket.

-- 
Neil n

Blog: Vanagons, Westfalia, general <http://tubaneil.blogspot.ca>

1988 Westy Images <https://picasaweb.google.com/musomuso/New1988Westy>

1981 Westfalia "Jaco" Images, technical <http://tubaneil.googlepages.com/>

Vanagon-Bus VAG Gas Engine Swap Group <http://tinyurl.com/khalbay>