Get this set ~ I have had 1 for several years & use it lots ~

http://www.sears.com/craftsman-3-pc-s-set/p-00943303000Pocket-cap

On 16 Nov , 2015, at 11:14 AM, Neil N wrote:

> Would a piece of steel square bar fit the 3/8" drive socket?
> Put an open end wrench on that?
> I've seen square tube at hardware stores.
> Would a suitable length of that be strong enough?
> 
> 
> On 11/16/15, Frank Condelli <RAlanen@aol.com> wrote:
> 
>>        As Denis says, however I have never needed to remove the pulley.  I
>> use 1/2� drive socket then use a 3/8 reducer inserted 1/2 way into the 24mm
>> socket then use a 1/2� ~ 13mm open end wrench on the reducer to turn the
>> socket.
> 
> 
> -- 
> Neil n
> 
> Blog: Vanagons, Westfalia, general <http://tubaneil.blogspot.ca>
> 
> 1988 Westy Images <https://picasaweb.google.com/musomuso/New1988Westy>
> 
> 1981 Westfalia "Jaco" Images, technical <http://tubaneil.googlepages.com/>
> 
> Vanagon-Bus VAG Gas Engine Swap Group <http://tinyurl.com/khalbay>