I used a socket that fit the sensor but only pushed it on enough to get it to hold.  That left enough of the end exposed to get a piece of a flex handle into the end but not all the way in as that would pull the socket out so it wouldn't grab the sensor.  It will work

Bob C

-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of John Rodgers
Sent: Sunday, December 06, 2015 5:04 PM
To: vanagon@GERRY.VANAGON.COM
Subject: 2.1L WBX high pressure oil switch - removal

I'm still struggling with this. Coolant pump pulley has been removed. Deep well socket to long, wom't fit in the space availabe;  standard socket to short , the blade/male connector of the switch is to long, can't seat the drive of the rachet.

Whats the secret for removal?

Thanks,

Jon