John,
   Some times you have to make a "special tool".  If you were to shorten
the deep socket by cutting some of it off, would it then be usable?  I
don't think I had to go to such lengths when I did this job, but it was a
long time ago.  It seems to me that I used a standard depth socket, but did
not put it all the way onto the sensor.  Then by putting the rachet only
part way into the socket, everything just barely worked.
   Cutting a socket, of course is not easy.  Using a dremel takes a long
time and many disks.  A larger tool with abrasive disk is faster, but you
want to go slow to avoid heating the socket too much and softening the
steel.  I recall cutting down a socket to get the crank pulley bolt off a
SAAB 900.  Its engine is in there backwards with the crank pulley tight
against the firewall.  What fun.

Larry A.

On Sun, Dec 6, 2015 at 5:03 PM, John Rodgers <jrodgers113@gmail.com> wrote:

> I'm still struggling with this. Coolant pump pulley has been removed. Deep
> well socket to long, wom't fit in the space availabe;  standard socket to
> short , the blade/male connector of the switch is to long, can't seat the
> drive of the rachet.
>
> Whats the secret for removal?
>
> Thanks,
>
> Jon
>