Yeah, that's what I'll do. Thanks for the reassurance Mark.

Alistair

> On Dec 9, 2015, at 11:02 AM, vw_van_fan_Mark <madvws@cox.net> wrote:
> 
> For a Syncro I would solder a wire pigtail onto the starter spade with heatshrink over it. Then a male spade for the other end. Put the new spade junction where you can reach it from the engine compartment.
> 
> Mark
> 
> Alistair Bel wrote:
>> Vanagon mailing list subject effect got me yesterday. Starter failed on my 86 syncro. I was lucky to get access to lift and got the bugger out last evening.
>> 
>> Commutator very dirty, brushes down to a nub. I've dropped it off at local rebuilder and it is promised to be done this afternoon.
>> 
>> For some reason I prefer having the local company rebuild ( they can rewind armature if needed) than use a factory recon. I've been very pleased with their work on alternators in the past.
>> 
>> I'm thinking about what to do about the ign switch wire to the solenoid. I don't like how it is an exposed spade connection. I had to make a field repair a few years ago when that connection came loose. When I had the engine out later, I added a pigtail and installed a relay and that worked out fine. But I still relied on a plain Jane spade connection to the solenoid.
>> 
>> I'm wondering if I should solder the spade connection on to the solenoid and then seal all up with liquid electrical tape.
>> 
>> Alistair
>> 
>>