I usually just break all of the welds by grabbing them with a pair of vise
grips and giving them a few quick back and forth motions until that snap
off or loose.  You aren't going to be reusing them again anyway.  Should
have gotten a set of clips to put the box back together when you are done.

Ken

On Wed, Jan 13, 2016 at 4:55 PM, Robert Clemmer <n51219@comcast.net> wrote:

> I'm sure this has been discussed else where, but I'm not so good on
> searches.
>
>
>
> What is the best way to split the glued heater box?  Will heat at the seams
> help?  I have a feeling that new words will be invented before I'm done.
>
>
>
> Thanks, Bob C
>

--
Thanks,
Ken Wilford
John 3:16
www.vanagain.com