

| Subject: | Re: Steering Knuckle Axle Stub Wear PICS |
| From: | OlRivrRat |
| Date: | Sat, 9 Jan 2016 17:42:52 -0700 |
& a Couple of other Links ~ Do these Fit Under Our GreaseCaps OK ~ https://www.fcpeuro.com/products/porsche-axle-nut-front-por-91134167300 http://www.rmeuropean.com/Products/91134167300-MFG127.aspx On 8 Jan , 2016, at 10:06 PM, Ed McLean wrote: > To keep the threads from being damaged on the end of the spindle by the > peen nut, replace it with the spindle clamp nut from a '70 to '84 > Porsche 911 (Porsche P/N 911 341 673 00). This will allow bearing pre- > load to be easily adjusted accurately. Search the list for Porsche and > my email address for the notes I have submitted . > > I have been using these for 3.5 years with SmallCar's big brake kit. I > would imagine they would also fit the standard Vanagon front wheel > bearings but I haven't tried them because I only have one Vanagon.. > > Here's a picture: http://www.autoatlanta.com/Porsche-91134167300- > srch.html > > Ed > > > Edward Maglott <emaglott3@GMAIL.COM> wrote: > >> I can't tell by looking but I had a stub axle that got worn to the > point I >> could not adjust the wheel bearings properly. there was play where the >> outer bearing mated to the stub axle. I had a warped brake rotor and > let >> it go too long which I believe eventually caused this problem. >> Edward >> >> On Fri, Jan 8, 2016 at 12:55 PM, Neil N <musomuso@gmail.com> wrote: >> >>> Hi all. >>> >>> In light of steering knuckle chat, purely for the sake of gaining >>> knowledge.... >>> >>> Close up images of bearing race wear on a '85 non PS steering > knuckle: >>> >>> https://picasaweb.google.com/musomuso/January82016# >>> >>> Hard to say without measuring, but is this knuckle now unserviceable? >>> Or, would new bearings fit tight enough so each race wouldn't spin on > axle? >>> Is this wear typical? Does it indicate that the bearings >>> were set too loose? (they were well lubed). >>> >>> My guess is that a new set of properly adjusted bearings should last > a >>> while on a >>> part in this condition. Or would they? >>> >>> >>> Thanks >>> >>> Neil. >>> >>> -- >>> Neil n >>> >>> Blog: Vanagons, Westfalia, general <http://tubaneil.blogspot.ca> >>> >>> 1988 Westy Images > <https://picasaweb.google.com/musomuso/New1988Westy> >>> >>> 1981 Westfalia "Jaco" Images, technical > <http://tubaneil.googlepages.com/> >>> >>> Vanagon-Bus VAG Gas Engine Swap Group <http://tinyurl.com/khalbay> >>>
Have something to add on this topic today? Revive this thread in the forum »