Dennis,

Thanks for the very informative response.

I don't understand "a bit of play on the flanges".  Does this mean the
inner sleeves were a little short and spacers were required to allow a
tight fit on the alignment washers without overloading the outer flange
of the Delrin AF insert?

Thanks,

Ed

On Tue, 19 Jan 2016 20:56:43 -0500, Dennis Haynes
<d23haynes57@HOTMAIL.COM> wrote:

>I have used both the GoWesty (once) and the T3 Technique (many times)
upper
>bushings. The T3 uses 2 sleeves and a polyurethane element which does
>require lubrication at install. The grease that comes with the kit is
not
>enough, get the tube of special grease he also sells. I think that is a
>better grease also. The T3 bushings are still my favorite. The fit and
the
>way the arms move is amazing and there is still some soft cushioning.
>
>The GoWesty set uses sleeves the same way and they also provide the
>eccentric washers. The material between the sleeves is relatively hard
and
>it appears to be self-lubricating. The fit of the outer sleeves in the
arm
>was very tight and with the almost no friction action of the set up
should
>not ever come loose. On the set I installed there was just a bit of
play on
>the flanges and when driving this made some weird noises. McMaster Carr
had
>some shims that fit so I ordered some. I ended up putting 2mm on one
side
>and 3mm on the other and all is well. Due to the suspension geometry I
>really can't say these harder bushing set ups affected the ride much.
It
>will take some time to see if there are any issues. I did have one T3
>bushing fail and Chris replaced the complete set gratis. Both are a
great
>improvement over the standard offerings. If on a Budget go GoWesty. If
>you're doing other bushings-mounts consider going T3 for all.
>
>Dennis
>
>
>-----Original Message-----
>From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf
Of
>Ed McLean
>Sent: Tuesday, January 19, 2016 9:27 AM
>To: vanagon@GERRY.VANAGON.COM
>Subject: Re: Upper control arm bushings failed again, upgrade advice
sought
>
>Does anyone have any experience with the GoWesty Delrin AF UCA
bushings?
>Any harshness noted?  They advertise no squeak with no grease and imply
very
>long life.