Well, three years ago I replaced the ball joints, tie rod ends and upper
control arm bushings on my '86 Westy, putting grease fittings in the
ball joints and tie rod ends.  The greased joints are still tight but
the upper control arm bushings are clunking and squeaking on one side
once again.  Only a long time Vanagon owner can appreciate how
frustrating this is.  I can't recall how many times I have done this in
the past 24 years.

So it's time to fix it again and I can't see using original design
bushings so I'll ask the list to share its knowledge.

Are there upper control arm bushing upgrades other than those produced
by GoWesty and those produced by T3 Technique?

What experience have people had with these upgrades?  What problems?

How many miles do you have on them and are they still tight?  Do they
make noise?  Have any failed?  Is there a noticeable difference in the
ride?  Are GoWesty bushings secure without spot welding? What is your
perception of the design and quality of the parts?  Do you have any
other comments?

I appreciate any and all comments about the upper control arm bushings.
You may post these back to the list or send them only to my email if you
wish.

Thanks in advance.

Ed