I wasn't sure if rebuilders installed new bushings, cross shaft etc.
as a matter of course.
I see that job from the POV of someone adventurous enough to rebuild a
clutch housing.
(this job isn't too hard.... in hindsight. haha)

But the oil slinger. Yes. Andrew Libbey did a nice write up on this
potential issue
over on the samba Vanagon forum.

Neil.

On 3/9/16, Dennis Haynes <d23haynes57@hotmail.com> wrote:
> Part of a good trans overhaul includes a good inspection and rebuild of the
> clutch cross shaft and bushings. It is the heart of having smooth clutch
> operation. Also, there is the oil slinger that is pressed in behind the oil
> seal. These often get popped loose or the inner groves trashed for a pilot
> bearing failure. Without this piece you end up with a trans that always
> leaks some at that shift seal. There is little shipping savings not having
> the bell housing attached and lots of room for debris to get it in.

--
Neil n

Blog: Vanagons, Westfalia, general <http://tubaneil.blogspot.ca>

1988 Westy Images <https://picasaweb.google.com/musomuso/New1988Westy>

1981 Westfalia "Jaco" Images, technical <http://tubaneil.googlepages.com/>

Vanagon-Bus VAG Gas Engine Swap Group <http://tinyurl.com/khalbay>