Skip to main content
Gerry | Vanagon
Checking account...
← vanagon.com home · Continue the discussion in the forum
Subject:Re: Manual tranny clutch adjustment,
From:Jim Felder
Date:Sun, 17 Apr 2016 21:38:44 +0000

It's an Alabama car. No corrosion. I've seen it. Not the bracket per se,
but nothing on the car is rusty or corroded.

Jim

On Sun, Apr 17, 2016 at 4:21 PM John Rodgers <jrodgers113@gmail.com> wrote:

> Considering the shifting probems: (1) the transmission is freshly
> overhauled (2) a new clutch and throwout bearing was installed. (3) all
> external wear-type shift components were replaced a few years ago from
> front to rear. Perhaps it's time again and they can be adjusted properly
> then. No other components replaced.
>
> I did not get to see this installation myself, which I usually do, but the
> work was done by an old time VW mechanic who now works on nothing but older
> Volkswagens, primarily Beetles, aircooled buses, and Vanagons. I can only
> assume he did it right until proven otherwise. But, he had no instructions
> to replace any external shifter components.
>
> John
> On Apr 17, 2016 14:29, "Neil N" <musomuso@gmail.com> wrote:
>
> > Not to take this further 'all over the place' but given the corrosion
> > wear I'm seeing on my transmission case and clutch housing, I'd
> > suggest watching the clutch slave bracket while the clutch pedal is
> > being pushed.
> >
> > I've read that a rusty slave bracket can fail.
> >
> > And though this is unlikely, given that Johns transmission is a
> > rebuilt, could the tube on clutch housing that the slave bracket
> > mounts on (where clutch shaft passes through) corrode badly enough to
> > fail and allow bracket to move at that point thus limiting how far the
> > slave can push the clutch lever?
> >
> >
> > Neil.
> >
> >
> > On 4/16/16, Dennis Haynes <d23haynes57@hotmail.com> wrote:
> >
> > > ..... I have seen trans overhauls that did not include clutch
> replacement
> > > or replacement of the operating shaft or bushings. His problem could be
> > > mechanical or maybe even just the hydraulics. It is possible for the
> > pedal
> > > cylinder to fail in way that it just doesn’t move the clutch cylinder
> as
> > it
> > > should either.
> > --
> > Neil n
> >
> > Blog: Vanagons, Westfalia, general <http://tubaneil.blogspot.ca>
> >
> > 1988 Westy Images <https://picasaweb.google.com/musomuso/New1988Westy>
> >
> > 1981 Westfalia "Jaco" Images, technical <
> http://tubaneil.googlepages.com/>
> >
> > Vanagon-Bus VAG Gas Engine Swap Group <http://tinyurl.com/khalbay>
> >
>