At 10:29 AM 5/4/2016, Jim Felder wrote:
>has too many other problems. Is there a way to jumper something to
>something to make the indicator work? It's a shame that it's like it is as
>it is the only thing on the entire car that doesn't work properly.

Of course.  There's nothing magic about the flexible circuit, it's
just wires with a few components (an LED and a resistor in this case)
stapled into them.  Don't have Bentley with me right now but the
circuit goes from outside the resistor, then the LED, then panel
ground (or it's conceivable that it goes from panel supply to the
resistor, then the LED, then outside).  Use your meter and find out
where it's losing continuity (the LED itself won't show continuity
but depending on your meter will respond to a diode test in the right
direction, and the resistor will be to high to show continuity but
will measure probably 470 ohms on a resistance scale.

Use your bad flex circuit to practice cutting and peeling up the
thinner of the two plastic sheets covering the circuit, then scraping
the copper foil bright and gently soldering to it.  Max 25 watt iron
(15 watt might be preferable), use 22-26 ga stranded wire for a nice
flexible jumper that won't stress the joint.

Yrs,
d